Shenzhen Lee&Jack Power Technology Co.,Ltd
Shenzhen Lee&Jack Power Technology Co.,Ltd ---Focus on medical batteries for 9 years
Add to Cart
10.8V 7800mAh Li-ion Monitor Battery For Philips MP20 MP30 MP40 MP50 MP60 MP70 MP80 MP90 M8001A M8002A M8100 M4605A
Product Information
| Brand | Lee&J. Power |
| Reference | LH-PHM300MD |
| Color | Black |
| Type | Li-ion |
| Capacity | 7800mAh |
| Voltage | 10.8V |
| Weight | 476g |
| Size | 149 x 89 x19.7 mm |
| Warranty | 12 months |
| Replace Code | M4605A, 989803135861 |
| Suitable For | Philips MP20 MP30 MP40 MP50 MP60 MP70 MP80 MP90 M8001A M8002A M8100 |
Detail Image
About the Battery
The rechargeable Lithium-Ion batteries used in the monitor are regarded as Smart batteries because they have built-in circuitry. (This circuitry communicates battery-status information to the Monitor.)
To get the most out of the batteries, observe the following guidelines:
- Condition the batteries only upon maintenance request prompt on display.
- If a battery shows damage or signs of leakage, replace it immediately. Do not use a faulty battery in the Monitor.
- Capabilities of integrated battery charger: 12.6V, 5 Amps mx.
Actual current / voltage: depends on smart battery request and monitor configuration
The approximate charging time is 4 hours with the monitor switched off and up to 12 hours during monitor operation, depending on the monitor configuration.
- Battery Disposal—Batteries should be disposed of in an environmentally-responsible manner. Consult the hospital administrator for local arrangements.
Do not dispose of the battery in normal waste containers.
- Battery Storage — Batteries should not remain inside the monitor if they are not used for a longer period of time. Batteries should be max. 50% charged for storage.
NOTE
Batteries will discharge within about 20 days if they are stored inside the monitor without AC power connection.
Checking the Battery Status
When the Monitor is connected to the AC power supply, the battery charges automatically. The battery can be charged remotely from the Monitor by using the battery charger.
Battery status (level of charge) is indicated several ways:
- LED on the front panel of the Monitor.
- Battery gauge.
- Display of battery time below gauge.
- Battery status window.
- INOP messages.
The AC Power LED is only on when the power cord is connected and AC power is available to the Monitor. In this case, the battery can be either charging or fully charged.
The battery LED can be green, yellow, or red depending on the following conditions:
| Battery LED Colors | If the monitor is connected to AC power, this means | If the monitor is running on battery power, this means |
| Green | batteries full (>90%) | |
| Yellow | batteries charging battery down2 | |
| Red, flashing | less than 10 minutes power remaining | |
| Red, flashes intermittently | battery malfunction1 | battery malfunction1 |
| Red, flashes once when on/standby switch is pressed | not enough battery power left to power monitor |
1 indicated by malfunction symbol and INOP
2 indicated by “battery has no power left” symbol
NOTE
If the batteries were charged to 100%, they will not charge again until the charging status goes below 90%.
If the remaining battery-operating time is less than 10 minutes, the LED flashes red at a repetition rate of approximately 1.5 flashes per second.
When the batteries are empty, the Monitor switches off automatically (including the green On-Off/Standby LED on the front panel). Attempts to restart the Monitor (by pressing the On-Off/Standby) causes the red LED to emit a single flash. (The flash may have a delay of up to 2.5 sec after pressing the On-Off/Standby key). In this case either recharge the batteries (externally or internally) or exchange the batteries.
NOTE
If the batteries become too warm or too cold, they will not begin the recharging cycle until the battery temperature is within range.
Product Description
This battery has been manufactured with high-quality components. It complies with every particular of the orginal manufacturer's regulations and is guaranteed against all manufacturing defects.
A margin of 0.1V difference in the voltage is negligible in batteries. Therefore, such a battery would still be perfectly compatible. If the capacity (mAh) of the replacement battery is higher than that of the original battery, this will allow for a longer usage time.
Contact US
Big wholesale order is acceptable and the price is negotiable, please contact us for details.
OEM is also welcome. Please tell us the details of the product you want, then we can design and customize it for you.
Do not hesitate to contact us anytime before and after your purchase. If you have any questions on your purchase, please let me know via "contact now" or by email. We will solve it for you.
We are committed to ensuring that you are completely satisfied with every transaction. 100% Satisfaction guaranteed !
We will reply your mail within 24 hours normally. sometimes have a little delay due to the weekends or holidays.
(we work from Monday to Friday (8-17:30 GTM+8)
If you can't get our mail after 48 hours, please check your spam or contact to us. If you email us and I will be on service of you until you are satisfied with your purchase.